Forum
WARNING:This product contains nicotine. Nicotine is an addictive chemical.

Cacuq Teaches You to Recognize The Commonly Appeared Notice on The Screen of Mods

Launch Time: 2016-11-14 Views: 1994 Rely: 0 Started by:


Hello everyone, how is your weekend and how is your vaping? Today, we will discuss some problems relating to your mods. Have there are some warnings or notices on the screen of your mod, which you can’t figure out the meaning or reason. Don’ t worry, Ceci from Cacuq today will help you recognize the warnings and get you out of the puzzles.

 

1.“Check atomizer”

 

 

 

One of the friends let its mod throw into the ground and then it appeared“Check atomizer
”on the screen.Have you even experienced this?

 

There are two reasons causing the “check atomizer”. One is the broken of the connection and the other is short cut. Furthermore, the reasons causing the broken of connection will bother most of the vapers and as for the conditions, they are the loose of the atomizers, the screws of the deck haven’t been tightened or the inappropriate contact of the atomizer 510 connector and the connector of the base. If the reasons are those as said above, we can test by the extra equipments.While after he changed the atomizer, the screen still show that “check atomizer”, under that circumstance, there is no possibility of broken of connection so we have to see from the short cut.Some chips equipped with the mod are without the information of “shorted” so after your application of the atomizer, the show of “CHECK ATOMIZER” or “NO ATOMIZER” still exist, we can use other used atomizers to test the short cut problem. There are still a problem to cause this, that is the debris on the connector to cause this.

 

2.“Shorted”

 

 

 

 

Do you know the meaning of “shorted” on the screen?That means the short circuit.

Cause: if your atomizer gets short circuit or the resistance is under a rarely low resistance such as 0.05Ω, the chip of the mod will be tested as short circuit. The low resistance will lead to high currency, usually as high as several times of the normal currency, so as to cause heat effect to damage the battery or components.

 

3.“New atomizer”

 

 

 

 

Cause:when a new atomizer is equipped to the mod, the screen will show you “New atomizer” and you should confirm to use the kit while the the screen will show the previous resistance.

 

4.“LOW BATTERY”

 

 

 

 

Cause:if the mod is running under the 3.4V, there will be “low battery” and under this circumstance, you should change the battery or charge the mod, almost when it is reaches 1/3, you should take notice.

 

5.Ohms Too Low or LOW ATOMIZER

 

 

 

 

Cause:different brand and model kits have different chips so to protect the chips from being damaged by the too-low or too-high resistance, every chip will be set a bearing voltage range so we can know the range from the specification book and if there are the notice of the “Ohms Too Low or LOW ATOMIZER ”, we should adjust it.


6.DEVICE TOO HOT

 

 

 

 

Cause:this is commonly seen in the mods produced from an early age because during the importing of the power, the chips will release power and in order to protect the chip from being damaged by the heat, the chip will be equipped with the reaction of the temperature and once the heat reaches the range, the mod will go into the heat dissipation mode.

 

7.TEMPERATURE CONTROL

 

 

 

Cause:under the TEMPERATURE CONTROL mode, the temperature reaches the setting standard so there is nothing serious problems with your mod, just getting you from damages of the mod.